It is not easy for people to encounter unexpected situations during the entire process of using cycloidal gear reducers in an appropriate way. However, there are some abnormal phenomena that must be paid attention to in advance. So what are the actual abnormal phenomena? Everyone, please take a look at the detailed introduction in the next article first, so that you can pay more attention in the future.

During the entire application process, the cycloidal pinwheel reducer may sometimes cause the reducer to overheat or cause noise.

If you encounter such a problem throughout the application process, what you must do is to find the cause and find a solution? Below are two aspects of the problem: several reasons for the overheating of the reducer in the cycloidal pinwheel reducer: insufficient or excessive lubricating oil; Insufficient or insufficient lubricating oil; Excessive friction in the skeleton seal; The connection between the output shaft and the transmission is incorrect.

The key solution is to integrate the load or select large and medium-sized physical models; Add moderate lubricating oil as indicated; Add appropriate lubricating oil after oil drainage; Drip a small amount of lubricating oil onto the skeleton seal; Adjust to a moderate position.

The noise of the cycloidal pinwheel reducer includes: worm gear, worm gear teeth; Damaged or excessive clearance of rolling bearings; Insufficient lubricant; Dirty things invade.

The key solution is to trim the surface of the front teeth; Dismantle and replace the rolling bearings; Add an appropriate amount of lubricating oil according to the instructions for use; Remove dirt and replace lubricating oil.

The above is an analysis of some common abnormal phenomena in cycloidal pinwheel reducers. If you encounter them in the future, you should follow the above manuscript to solve them.

• Structural char...下一篇
• Then we can mea...上一篇