It is not easy for people to make mistakes when installing gear reducers if they strictly follow the operating procedures, which can ensure the normal operation of the gear reducer.

If everyone finds that the gear reducer does not comply with relevant specifications and regulations after installation, it is better to find the actual reason and carry out the installation again.

The gear reducer manufacturer stipulates that the configuration accuracy of the gear reducer must meet the rules and regulations, and strictly follows the configuration production process of the gear reducer manufacturer's rules and regulations to promote it.

All parts that have not been inspected by the traditional handicraft inspection department as qualified, accepted, unprinted, or painted are prohibited from being configured.

The assembly, assembly, and welding of gear reducers obviously need to be carried out in sequence according to the configuration process flow, which cannot lead to interference in the process flow.

If the gear shaft inside the shaft has not been installed, first configure the bearing shaft.

The gear reducer cover and motor shaft mating surface do not require the use of each sealing gasket.

Before configuration, the components should be brushed, and the roller bearings should be brushed with oil or cost-effective brushing agents, with high-pressure air drying.

Each harmonious surface does not need to be changed during configuration.

The mechanical and electrical maintenance contract obligations for required components, such as keys and keyways.

Before placing the roller bearings on the shaft, they should be heated to 80-1 ° C in the paint and then subjected to thermal expansion.

The transmission of force should go through the inner ring of the roller bearing.

Install the unprinted side against the surface of the support point during configuration.

After the gear reducer is configured, a trial run should be carried out, and the speed of the trial run should be close to the output power speed of the reducer. It is strictly prohibited to add WeChat friend grinding fluid and sediment to the lubricating grease during the trial run. The contact rate of the tooth surface should meet the level requirements of the regulations.

After the gear reducer is qualified, the traditional manual inspection position is printed and an appraisal certificate is made. The slow reducer that has not been inspected and qualified cannot be equipped with machine warning and personnel storage. The confidential information of the packaged slow reducer includes the appraisal certificate and common installation and maintenance problems.

In other words, installing the gear reducer according to the above method is generally not prone to errors. We hope everyone can follow the relevant installation specifications.

• When the cycloi...下一篇
• The milk tea br...上一篇